For laboratory research use only — not for human or veterinary consumption.
The Peptide Index
Dosing guide

Thymosin Beta-4 Dosage Chart & Schedule

Thymosin beta-4 is a naturally occurring 43-amino-acid peptide and a major intracellular actin-sequestering molecule. It is the full-length parent from which the research fragment commonly sold as TB-500 is derived, and it is studied for tissue repair, angiogenesis, and cell migration. It remains investigational.

Route
Subcutaneous
Frequency
1-2x per week
Half-life
Reported plasma half
Storage
Lyophilized: refrigerate or freeze. Reconstituted: refrigerate, use within weeks.
The short answer

In the research literature, the full-length thymosin beta-4 peptide is typically referenced at low-milligram subcutaneous doses (around 2-2.5 mg) given one to two times weekly across multi-week cycles, then tapered. Human injectable dosing is not established.

Figures describe how Thymosin Beta-4 is reported in the research literature and research-community references — not a recommendation for human use. For laboratory research only.

Dosage protocols

Commonly referenced research tiers. Start conservative; every compound and study context differs.

Conservative
2 mg
About 0.4 mL of a 5 mg/mL mix (40 units on a U-100 syringe).
Frequency
Once weekly
Weekly total
2 mg/week
Cycle
4-6 week cycle

Lower end of the referenced range; sometimes used before a loading phase.

Most commonStandard (loading)
2-2.5 mg
About 0.4-0.5 mL of a 5 mg/mL mix (40-50 units).
Frequency
Twice weekly
Weekly total
4-5 mg/week
Cycle
4-6 week loading phase

The most commonly referenced loading pattern for the full-length peptide.

Maintenance
2-2.5 mg
Same per-dose amount, spaced further apart.
Frequency
Once weekly or every other week
Weekly total
~1-2.5 mg/week
Cycle
Ongoing after loading

Reduced frequency after an initial multi-week loading period.

Full-length peptide vs the TB-500 fragment

  • Thymosin beta-4 is the complete 43-amino-acid parent molecule; TB-500 is a shorter actin-binding fragment derived from it.
  • Pharmacokinetics of the full-length 43-mer differ from the fragment, so dosing references are not interchangeable.

Ready to run this protocol?

Dosing is only as good as the vial. Research-grade peptides are third-party tested with published COAs from our top-rated source — reconstitute with confidence and skip the guesswork on identity and purity.

Weekly schedule

A typical week on the standard (loading) protocol (Twice weekly).

Mon
Tue
Wed
Thu
Fri
Sat
Sun

Dosing day Off

Thymosin Beta-4 reconstitution

10 mg vial + 2 mL bacteriostatic water = 5,000 mcg/mL (5 mg/mL); 1 unit is approximately 0.05 mg (50 mcg).

Concentration
5,000 mcg/mL
Per syringe unit
50 mcg
Draw for 2.5 mg
50 units
Doses per vial
~4
Open this mix in the calculator →

From vial to injection in 6 steps

1

Wipe both vial tops

Swab the peptide vial and the bacteriostatic-water vial with fresh alcohol and let them dry.

2

Draw the water

Pull the planned amount of bacteriostatic water (2 mL) into the syringe.

3

Add it slowly

Run the water down the inside wall of the vial — don't blast the powder. Swirl gently; never shake.

4

Let it dissolve

Wait until the solution is fully clear, then refrigerate the vial.

5

Draw your dose

Pull the calculated units on a U-100 insulin syringe (~50 units for 2.5 mg).

6

Store between uses

Keep the reconstituted vial refrigerated and use within its stable window.

Handling & storage

  • Reconstitute with bacteriostatic water down the vial wall; do not shake, swirl gently to dissolve.
  • A 10 mg vial with 2 mL yields 5 mg/mL, so 1 unit on a U-100 syringe is about 50 mcg.
  • Store the sealed lyophilized vial refrigerated or frozen; keep the reconstituted vial refrigerated.
  • Investigational research compound; not an approved drug.

Thymosin Beta-4 dosing FAQ

How much thymosin beta-4 per injection is referenced?

Research-community references for the full-length peptide commonly cite about 2-2.5 mg per subcutaneous injection, mirroring TB-500-style amounts.

How often is it dosed?

Most references use a loading phase of twice weekly for several weeks, then taper to once weekly or every other week. Reported half-life is on the order of hours, but the actin-related effects are studied over a longer window, which is why weekly dosing is common.

How do I reconstitute a 10 mg vial?

Adding 2 mL of bacteriostatic water gives 5 mg/mL. On a U-100 syringe that makes 1 unit about 50 mcg, so a 2.5 mg dose is 0.5 mL (50 units).

Is thymosin beta-4 the same as TB-500?

No. TB-500 is a shorter fragment of this parent peptide. They are studied for similar repair-related effects, but the dosing references are tracked separately.

Sources

Categories: Healing & Recovery · Status: Approved (see notes). This page is educational and for laboratory research use only; it is not medical advice.