For laboratory research use only — not for human or veterinary consumption.
The Peptide Index
Dosing guide

Tesamorelin Dosage Chart & Schedule

A stabilized GHRH analog that is FDA-approved (as Egrifta) to reduce excess visceral adipose tissue in HIV-associated lipodystrophy — one of the few peptides in this index with an approved human indication.

Route
Subcutaneous
Frequency
Once daily
Half-life
Approximately 26–38 minutes
Storage
Refrigerate reconstituted; use promptly; keep vial cool and dark
The short answer

Unlike most entries here, tesamorelin has an FDA-approved regimen: 2 mg subcutaneously once daily (as Egrifta) for HIV-associated lipodystrophy. This is a labeled human dose, not merely a research convention.

Figures describe how Tesamorelin is reported in the research literature and research-community references — not a recommendation for human use. For laboratory research only.

Dosage protocols

Commonly referenced research tiers. Start conservative; every compound and study context differs.

Most commonApproved regimen
2 mg
per injection
Frequency
Once daily
Weekly total
14 mg
Cycle
Ongoing per label (clinical)

The FDA-approved Egrifta dose for reducing excess visceral abdominal fat in HIV-associated lipodystrophy; a fixed dose, not titrated.

FDA-approved (Egrifta)

  • Tesamorelin is approved as Egrifta / Egrifta SV to reduce excess visceral abdominal fat in HIV-associated lipodystrophy.
  • The labeled dose is 2 mg subcutaneously once daily, one of the few approved compounds in this index.

Raises IGF-1

  • By increasing growth hormone it raises IGF-1; clinical labeling monitors IGF-1 and cautions in certain populations.
  • This oversight distinguishes it from the unapproved secretagogues elsewhere in this index.

Ready to run this protocol?

Dosing is only as good as the vial. Tesamorelin is third-party tested with published COAs from our top-rated source — reconstitute with confidence and skip the guesswork on identity and purity.

Weekly schedule

A typical week on the approved regimen protocol (Once daily).

Mon
Tue
Wed
Thu
Fri
Sat
Sun

Dosing day Off

From vial to injection in 6 steps

1

Wipe both vial tops

Swab the peptide vial and the bacteriostatic-water vial with fresh alcohol and let them dry.

2

Draw the water

Pull the planned amount of bacteriostatic water (2 mL) into the syringe.

3

Add it slowly

Run the water down the inside wall of the vial — don't blast the powder. Swirl gently; never shake.

4

Let it dissolve

Wait until the solution is fully clear, then refrigerate the vial.

5

Draw your dose

Pull the calculated units on a U-100 insulin syringe.

6

Store between uses

Keep the reconstituted vial refrigerated and use within its stable window.

Handling & storage

  • The approved product is reconstituted with supplied sterile water; a 5 mg research vial + 2 mL bacteriostatic water = 2500 mcg/mL
  • Refrigerate reconstituted and use promptly; keep the vial cool and dark
  • At the 2 mL mix a 2 mg dose is ~0.8 mL (80 units); a smaller water volume reduces the injection size

Tesamorelin dosing FAQ

How much tesamorelin per day?

Its FDA-approved regimen is 2 mg subcutaneously once daily, about 14 mg/week, for HIV-associated lipodystrophy.

How is tesamorelin reconstituted?

The approved product uses supplied sterile water. For a 5 mg research vial, 2 mL of bacteriostatic water = 2500 mcg/mL, so 2 mg is about 80 units (0.8 mL) on a U-100 syringe.

Does tesamorelin need titration?

Unlike GLP-1 drugs, the approved tesamorelin dose is a fixed 2 mg/day and is not titrated up over time.

Is tesamorelin taken morning or night?

The approved label directs once-daily dosing without a strict time of day; unlike short GHRPs it is a single fixed daily dose.

Sources

Categories: Growth Hormone Secretagogues, GLP-1 & Metabolic · Status: Approved (see notes). This page is educational and for laboratory research use only; it is not medical advice.