Kisspeptin-10 Dosage Chart & Schedule
A decapeptide fragment of kisspeptin, a key upstream regulator of reproductive hormones, studied in fertility and reproductive-neuroendocrine research.
Kisspeptin-10 has no established therapeutic dose. In reproductive-neuroendocrine research it is given as short subcutaneous or IV boluses (or timed infusions) in the mcg range to probe GnRH and downstream LH/FSH signaling, and its half-life is only minutes.
Figures describe how Kisspeptin-10 is reported in the research literature and research-community references — not a recommendation for human use. For laboratory research only.
Dosage protocols
Commonly referenced research tiers. Start conservative; every compound and study context differs.
- Frequency
- Single dose or timed infusion
- Weekly total
- Not applicable - study-specific
- Cycle
- One-off administration in a research setting
No standard regimen exists; doses are experimental probes, not treatment.
Very short-acting
- Circulating half-life is on the order of minutes.
- Longer-acting forms such as kisspeptin-54 are studied when sustained exposure is wanted.
No standard regimen
- Published doses are study-specific - boluses versus infusions, often weight-based.
- They are experimental probes of the reproductive axis, not established protocols.
Ready to run this protocol?
Dosing is only as good as the vial. Research-grade peptides are third-party tested with published COAs from our top-rated source — reconstitute with confidence and skip the guesswork on identity and purity.
From vial to injection in 6 steps
Wipe both vial tops
Swab the peptide vial and the bacteriostatic-water vial with fresh alcohol and let them dry.
Draw the water
Pull the planned amount of bacteriostatic water (2 mL) into the syringe.
Add it slowly
Run the water down the inside wall of the vial — don't blast the powder. Swirl gently; never shake.
Let it dissolve
Wait until the solution is fully clear, then refrigerate the vial.
Draw your dose
Pull the calculated units on a U-100 insulin syringe.
Store between uses
Keep the reconstituted vial refrigerated and use within its stable window.
Handling & storage
- Reconstitute a lyophilized vial with bacteriostatic water; refrigerate the solution.
- The minutes-long half-life means timing relative to sampling matters more than a daily schedule.
- Investigational - there is no validated human dose or cycle.
- Keep lyophilized powder frozen and protected from light until use.
Kisspeptin-10 dosing FAQ
Is there a standard kisspeptin-10 dose?
No. It is investigational, and dosing in the literature is set per experiment - as a bolus or an infusion, frequently scaled to body weight - to study reproductive-hormone signaling.
Why is it given as a single bolus or infusion rather than daily?
Its half-life is only minutes, so studies use a bolus or a controlled infusion to capture the short LH/FSH response rather than a standing daily dose.
How does it differ from kisspeptin-54?
Kisspeptin-54 is longer-acting, so it is chosen when researchers want sustained stimulation, whereas kisspeptin-10 produces a brief, sharp signal.
Subcutaneous or intravenous?
Research uses both routes; the choice depends on the protocol and whether a rapid bolus or a steadier infusion profile is wanted.
Sources
Categories: Sexual Health · Status: Investigational. This page is educational and for laboratory research use only; it is not medical advice.