Hexarelin Dosage Chart & Schedule
A potent synthetic GH-releasing hexapeptide, structurally related to GHRP-6, additionally studied for cardiovascular-tissue effects in preclinical models.
Research references commonly cite ~100 mcg per dose, 1-2x daily, in shorter cycles because sustained frequent use is associated with receptor desensitization. Not established for human use.
Figures describe how Hexarelin is reported in the research literature and research-community references — not a recommendation for human use. For laboratory research only.
Dosage protocols
Commonly referenced research tiers. Start conservative; every compound and study context differs.
- Frequency
- Once daily
- Weekly total
- 0.7 mg
- Cycle
- Short blocks with breaks
A single daily dose referenced to limit the desensitization associated with frequent use.
- Frequency
- 2x daily
- Weekly total
- 1.4 mg
- Cycle
- Short blocks with breaks
The most commonly referenced pattern; doses stay near 100 mcg rather than escalating because hexarelin is potent and desensitizes.
Desensitization is a key caveat
- Hexarelin is a potent GHRP, but sustained frequent use is associated with receptor desensitization and a blunted GH response.
- Research references shorter cycles or breaks rather than continuous use, which is why doses stay low.
Cardiac-tissue interest
- Beyond GH release, research notes hexarelin interaction with CD36 receptors relevant to cardiac tissue in preclinical models.
- This is preclinical and not established for human use.
Ready to run this protocol?
Dosing is only as good as the vial. Research-grade peptides are third-party tested with published COAs from our top-rated source — reconstitute with confidence and skip the guesswork on identity and purity.
Weekly schedule
A typical week on the standard protocol (2x daily).
Dosing day Off
Hexarelin reconstitution
5 mg vial + 2 mL bacteriostatic water = 2500 mcg/mL.
From vial to injection in 6 steps
Wipe both vial tops
Swab the peptide vial and the bacteriostatic-water vial with fresh alcohol and let them dry.
Draw the water
Pull the planned amount of bacteriostatic water (2 mL) into the syringe.
Add it slowly
Run the water down the inside wall of the vial — don't blast the powder. Swirl gently; never shake.
Let it dissolve
Wait until the solution is fully clear, then refrigerate the vial.
Draw your dose
Pull the calculated units on a U-100 insulin syringe (~4 units for 100 mcg).
Store between uses
Keep the reconstituted vial refrigerated and use within its stable window.
Handling & storage
- Reconstitute with bacteriostatic water (2 mL into a 5 mg vial = 2500 mcg/mL)
- Refrigerate reconstituted; keep the lyophilized powder cool and dark
- A 100 mcg dose draws to ~4 units on a U-100 insulin syringe
Hexarelin dosing FAQ
How much hexarelin per dose?
Research references commonly cite ~100 mcg per dose, 1-2x daily, in shorter cycles because of desensitization. Not established for human use.
How is hexarelin reconstituted?
With bacteriostatic water. For example, 2 mL into a 5 mg vial = 2500 mcg/mL, so a 100 mcg dose is about 4 units on a U-100 syringe.
Why is hexarelin cycled rather than run continuously?
Sustained frequent dosing is associated with receptor desensitization and a reduced GH response, so research references shorter blocks with breaks.
Is hexarelin stronger than other GHRPs?
It is one of the more potent GH-releasing hexapeptides, which is why doses stay low (~100 mcg) and cycles stay short to limit desensitization.
Sources
Categories: Growth Hormone Secretagogues · Status: Research use only. This page is educational and for laboratory research use only; it is not medical advice.